The Navy is seeking a secure, low-cost capability for a passive seabed logistics delivery and stowage system. The system will be capable of delivering and storing supplies, equipment, and materials on the seabed for extended periods (24 months). The system should minimize reliance on expensive surface vessel support and specialized underwater vehicles for deployment and retrieval, thereby significantly reducing operational costs. There is nothing commercially available that does this. The system must provide secure, environmentally protected stowage for a variety of payload sizes and types and safeguarding against corrosion, biofouling, and other environmental factors. The entire system must have a cylindrical form factor of 19 inches in diameter and 51 inches in length, with a maximum dry weight is 1,000 lbs and able to withstand maritime deployment while maintaining and controlling descent to the seabed. The system will be optimized for the maximum amount of payload/minimized amount of command electronics contained within the system. The system must function regardless of its orientation on the seafloor and must be operational on the seabed for a minimum of 12 months (Threshold), 24 months (Objective). The payload must be pressure tolerant between 300 meters and 600 meters, and able to withstand differing bottom types, currents, sea growth, and corrosion without performance degradation, as well as currents up to 2 knots. The system must incorporate a low-power, acoustic communication system for remote monitoring of critical parameters (e.g., location, environmental conditions, payload status) and control of specific functions (e.g., retrieval/release mechanisms, scuttling). Consideration should be given to minimizing power consumption and maximizing communication range and reliability in challenging underwater acoustic environments. Horizontal acoustic communications ranges should approach 5 to 10 km. The system shall be capable of being retrieved from the seabed depth by surfacing or deploying a float to enable retrieval. Additionally, the system must be capable of scuttle/neutralization after a set time duration or after the payload is retrieved. A detailed Interface Control Document (ICD) will be provided as Controlled Unclassified Information (CUI). This ICD will specify the physical attachment points, as well as describe the umbilical and electronic communications to be received from the vehicle. Work produced in Phase II may become classified. Note: The prospective contractor(s) must be U.S. owned and operated with no foreign influence as defined by 32 U.S.C. § 2004.20 et seq., National Industrial Security Program Executive Agent and Operating Manual, unless acceptable mitigating procedures can and have been implemented and approved by the Defense Counterintelligence and Security Agency (DCSA) formerly Defense Security Service (DSS). The selected contractor must be able to acquire and maintain a secret level facility and Personnel Security Clearances. This will allow contractor personnel to perform on advanced phases of this project as set forth by DCSA and NAVSEA in order to gain access to classified information pertaining to the national defense of the United States and its allies; this will be an inherent requirement. The selected company will be required to safeguard classified material during the advanced phases of this contract IAW the National Industrial Security Program Operating Manual (NISPOM), which can be found at Title 32, Part 2004.20 of the Code of Federal Regulations.
No documents are available for this record yet.